Midea WHS-109FB1 Manuel du propriétaire

Model:WHS-109FB1/WHS-109FW1/WHS-109FSS1

9 DO NOT lay the appliance completely flat as this may damage the coolant system. 1. Start by removing the bracket from the bottom: remove screws and

10 2. Slide the door down, away from the hinge pin located on the top of the door. 3. Remove the plastic cover from door hinge first. Then

11 4. To install the bracket on the left side of the appliance, screw the two screws through the bracket and into the top of the appliance

12 6. Check that the door is aligned horizontally and vertically and that the seals are closed on all sides before finally tightening the b

13 TROUBLESHOOTING In case of malfunction, you can solve many common problems easily: Your upright freezer will not operate… Check if  Th

14 REQUESTING ASSISTANCE OR SERVICE If the problem is not due to one of the items listed in Troubleshooting, Contact the dealer or a

15 7) Children should be supervised to ensure that they do not play with the appliance. 8) If the supply cord is damaged, it must be replaced by the

21.26WHS-109FB1/WHS-109FW1WHS-109FSS1R600a,1.59Oz

fromWhen using, please use scissorsto cut out the plastic cable tiesin the picture from top tobottom, a total of three cable ties.

4 ceiling. If you are installing your upright freezer next to a fixed wall, leave enough space on the hinge side to allow that door swings

5 NOTE: Before performing any type of maintenance or installation, turn off and disconnect the upright freezer from the electrical source.

located

7 aluminum sheets or freezing containers and place it into the freezer. See the data plate on freezer’s back for the maximum permissible

8 Hand wash, rinse and dry all surfaces thoroughly. Do not use cleaning waxes, concentrated detergents, bleaches or cleaners containing pet